Xingte at the 2026 Inductor and Transformer Annual Meeting in Baoji

The China Electronic Components Association published a notice on 29 July 2026 about its Inductor and Transformer Branch 2026 annual meeting, held 12 to 14 August in Chencang District, Baoji, Shaanxi Province. The notice says Shenzhen Xingte Technology would exhibit high-precision winding equipment for transformers and inductors plus non-standard automatic lines at stand B-12. Because it was published before the event, it is an invitation, not a show report.

Macro view of a ferrite core and an enameled copper winding

Fig. 1 - Inductor and transformer equipment was the focus of the Baoji notice. Illustrative image, AI-generated. Not a photograph of this event or of Xingte equipment.

1. Event and source

The publisher is an industry association, and the page is marked as original content from that site. It names the organiser, the meeting, the dates, the city and district, the associated exhibition and the stand number. Much of the product and company detail that follows reads as material supplied by the exhibitor, so the two layers should be kept separate.

This is the only 2026 item in this set focused specifically on inductor and transformer production rather than motor stators, which makes it the most relevant source for magnetic component engineers.

2. Six products listed in the association notice

The figures below are the ones printed in the notice. Some are process descriptions, others are company-stated performance numbers; none is accompanied by a test protocol.

ProductStated process coverageCompany-stated figureNamed application
T-Core molded chip inductor winding machineServo pulse control, alternating odd and even turn selectionStated pass rate above 99 percentVR headsets, phones, tablets, earphones, watches
T+U inductor hot-press lineCold pressing, winding, enamel stripping, cutting, bending, pre-heat pressingNo figure givenLaptops, mobile communications, automotive electronics
Ignition coil automatic lineWinding, magnet insertion, welding, performance testingStated saving of 25 to 30 workers, 98 percent first-pass yield, four-product changeoverAutomotive ignition coils
Transformer automation lineWinding, soldering, assembly and electrical testingNo figure givenPFC charging inductors, transformers, chip magnetics
Flat wire multi-winding machineBending and heat setting for axial flux flat wire statorsNo figure givenNew energy vehicle drive components
Eight-axis precision winding machineMulti-specification magnetic coil winding12,000 rpm spindle speed, 0.01 mm positioning accuracyHome appliances, communications, industrial power

3. Company profile figures in the same notice

The profile supplied with the notice says the company was founded in 2011, describes it as a national-level key Little Giant enterprise, and gives a 36,000 square metre manufacturing base, more than 1,000 employees, over 400 R&D staff and more than 140 granted patents. These are useful scale indicators, but they are the exhibitor's own profile figures, not an audit.

Designations and patent counts should be checked against the relevant public registers if they matter to a supplier qualification. The notice gives no certificate number, patent list or registration identifier.

4. Before and after the event

The page is explicitly pre-event. It contains no attendance figures, no photographs from the stand, no signed agreements and no statement of which of the six products were physically demonstrated. A reader should not convert a planned exhibit list into a confirmed delivery.

For a buyer, the most useful next step is to ask which of these products have a current datasheet and a sample test procedure, and whether the stated labour saving and first-pass yield were measured on a specific customer part.

Sources: CECA, annual meeting exhibition notice, 29 July 2026 (association notice with exhibitor-supplied profile).