How to Back Up and Restore Winding Programs Without Losing Process Settings
A winding program is more than a traverse file: axis offsets, tension, reversal and bonding settings all live somewhere. This procedure covers freezing an approved version, exporting the full setting set, proving a restore on another controller, and re-running first article before production resumes.
How to Verify Wire Tension Before a Production Run: A Calibration Procedure
A tension setpoint is only meaningful if the delivered force has been checked. This procedure covers preparation, a repeatable measurement at the point of use, comparison against the process window, and the record that makes the next check comparable.
How to Set Up a New Winding Program: From Bobbin to First-Article Approval
A new winding program fails in the first turns, at the first crossover or during the first speed ramp. This step-by-step tutorial covers part and wire checks, the tension path, traverse geometry, a low-speed first article, a written baseline and a staged ramp to production takt.